CONTREX CX-1200 - Manual (Page 391)

C - 45
(Continued)
Appendix C: Parameter Summary Numeric Quick Reference (continued)
Analog Input 2 Reference B (CP-288) is used to scale the Auxiliary Board Analog Input 2 in EU. Enter the Analog Input
2 signal value for reference point B that corresponds to the EU’s that are entered in EU@AI2 RB (CP-289).
Minimum Value: -15.0 Maximum Value: 25
Default Value: 10.0 Units: Volts or milliamps
CP-289 EU@AI2 RB
EU at Analog Input 2 Reference B (CP-289) is used to scale the Auxiliary Board Analog Input 2 in EU. Enter the number
of EU for point B that corresponds to the reference value that is entered in AI2 RB (CP-288).
Minimum Value: -9999999 Maximum Value: 9999999
Default Value: 100.0 Units: EU
CP-290 AO Parameter
Analog Output Parameter (CP-290) identifies the Monitor or Control Parameter that is used for the Auxiliary Analog
Output. When the Analog Output Parameter (CP-290) is set to “0”, the value of AO DIRECT (CP-365) is used as the
output.
Minimum Value: 0 Maximum Value: 429
Default Value: 31 Units: Parameter Code
NOTE: The following Monitor and Control Parameters are not available for the Analog Output Parameter (CP-290):
MP-17 ....... AnlgCal Ref A
MP-18 ....... AnlgCal Ref B
MP-22 .......... CO Max Bits
MP-23 ..... CO DAC Range
MP-24 ................. AO Bits
MP-25 ............. AO Signal
MP-26 .................... DI 7..0
MP-27 .................. DI 15..8
MP-29 ... KeyPad Lockout
MP-38 .............. Ld EU/Tm
MP-45 ............. Cntrl Loop
CP-290 ....... AO Parameter
CP-291 AO Mode
Analog Output Mode (CP-291) identifies the mode of operation and calibration that are used for the Auxiliary Board
Analog Output signal.