AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 612
41-001343-01 Rev 03, Release 3.2.2
5-335
Configuring Audio Transmit and Receive Gain Adjustments
You can configure the audio transmit and gain adjustments using the configuration files only.
Use the following procedure to configure this feature.
Handsfree tx gain
The increased (+db) or decreased (-db) amount of signal transmitted from the base
microphone to the far-end party.
Audio mode
Allows you to configure how the d/f key (handsfree key) works. Audio mode has 4
options:
0 (Speaker) - Calls can be made or received using the handset or handsfree
speakerphone and can be switched between the two modes by pressing the d /fkey.
When on speaker, you can return to using the handset by placing the handset on
the cradle and picking it up again.
1 (Headset) - Calls can be made or received using the headset. Calls can be switched
between the headset and handset by pressing the d /fkey.
2 (Speaker/Headset) - Incoming calls are sent to the speakerphone. By pressing the d
/fkey, you can switch between the handsfree speakerphone, the headset, and the
handset.
3 (Headset/Speaker) - Incoming calls are sent to the headset. By pressing the d /fkey,
you can switch between the headset, the handsfree speakerphone, and the
handset.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
and Receive Gain Adjustment Settings”
on
Parameter
Description