AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 142

41-001343-01 Rev 03, Release 3.2.2
3-55
Registration Timeout Retry
Timer
sip registration timeout retry
timer
Specifies the length of time, in seconds, that the phone
waits until it re-attempts to register after a REGISTER
message times out.
If this parameter is set lower than 30 seconds, the phone
uses a minimum timer of 30 seconds.
For more information, see Chapter 4,
.
Registration Renewal
Timer
sip registration renewal timer The threshold value, in seconds, prior to expiration, that the
phone renews registrations. The phone will automatically
send registration renewals half-way through the registration
period, unless half-way is more than the threshold value.
For example, if the threshold value is set to 60 seconds and
if the registration period is 600 seconds, the renewal
REGISTER message will be sent 60 seconds prior to the
expiration, as half-way (600/2) > 60. If the registration
period was 100 seconds, then the renewal would be sent at
the half-way point as (100/2) < 60.
For more information, see Chapter 4,
.
BLF Subscription Period
sip blf subscription period
Specifies the time period, in seconds, that the IP phone
resubscribes the BLF subscription service after a software/
firmware upgrade or after a reboot of the IP phone.
For more information, see Chapter 4,
.
ACD Subscription Period
sip acd subscription period
Specifies the time period, in seconds, that the IP phone
resubscribes the Automatic Call Distribution (ACD)
subscription service after a software/firmware upgrade or
after a reboot of the IP phone.
For more information, see Chapter 4,
.
BLA Subscription Period
sip bla subscription period
Specifies the amount of time, in seconds, that the phone
waits to receive a BLA subscribe message from the server.
If you specify zero (0), the phone uses the value specified
for the BLA expiration in the subscribe message received
from the server. If no value is specified, the phone uses the
default value of 300 seconds.
For more information, see Chapter 4,
.
Blacklist Duration
sip blacklist duration
Specifies the length of time, in seconds, that a failed server
remains on the server blacklist. The IP phone avoids
sending a SIP message to a failed server (if another server
is available) for this amount of time.
For more information about Blacklist Duration, see Chapter
6, the section,
Parameter in
Aastra Web UI
Parameters in
Configuration Files
Description