AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 385)

5-108 41-001343-01 Rev 03, Release 3.2.2
For incoming intercom calls, an administrator or user can configure the following parameters:
Configuring Intercom Calls Settings
You can configure the Intercom feature using the configuration files or the Aastra Web UI.
Use the following procedures to configure Intercom calls on the IP phone.
Configuration File Parameters Web UI Parameters
• sip allow auto answer • Auto-Answer
• sip intercom mute mic • Microphone Mute
• sip intercom warning tone • Play Warning Tone
• sip intercom allow barge in • Barge In
Note: To configure incoming intercom calls using these parameters, see
“Configuring Intercom Calls Settings” on page 5-108 .
Note: An administrator can configure the incoming and outgoing
Intercom feature. A user can configure the incoming Intercom feature
only.
Configuration Files
For specific parameters you can set in the configuration files for outgoing Intercom, see Appendix A, the
section,
“Outgoing Intercom Settings” on page A-183.
For specific parameters you can set in the configuration files for incoming Intercom, see Appendix A, the
section,
“Incoming Intercom Settings” on page A-184.
Aastra Web UI
Outgoing intercom settings
1
Click on Basic Settings->Preferences->Outgoing Intercom Settings.
2 Select an Intercom type for outgoing Intercom calls from the Type list box.
Valid values are Phone-Side, Server-Side, Off. Default is Off.