Configuring xml for directed call pickup – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 411

5-134
41-001343-01 Rev 03, Release 3.2.2
Configuring XML for Directed Call Pickup
Use the following procedure to configure XML for Directed Call Pickup in the configuration
files.
Use the following procedure to configure XML for Directed Call Pickup in the Aastra Web UI.
Notes:
1.
Before implementing this procedure, you must create an XML
application that the phone uses when the XML softkey or programmable
key is pressed. This XML application must be entered as a URI in the
“Value” field of the XML key. For information about creating an XML
script, see the Aastra XML Developer’s Guide.
2.
You must enable Directed Call Pickup before performing these
procedures. See
“Enabling/Disabling Directed Call Pickup”
on
Configuration Files
To set XML in the configuration files for Directed Call Pickup, see Appendix A, the section,
Programmable Key/Feature Key/Expansion Module Key Parameters”
Aastra Web UI
1
Click on Basic Settings->Preferences->Directed Call Pickup Settings.
2
Enable the "Directed Call Pickup" field by checking the check box.
3
(optional) Enter a prefix in the "Directed Call Pickup Prefix" field. For example, *98.
This prefix is appended to the beginning of the Directed Call Pickup number when dialed from the
BLF or BLF/List softkey.
4
Enable the "Play a Ring Splash" field by checking the check box.
The IP phone plays a short "call waiting tone" when there is an incoming call on the BLF monitored
extension. If the "Play a Ring Splash" parameter is enabled, and the host tone is idle, the tone plays
a "ring splash".