Demonstration, Operation manual, Tool changes – ACU-RITE MILLPWR 3 Axes User Manual
Page 96: Clearing the program
DEMONSTRATION
MILLPWR
®
Operation Manual
4-20
Tool Changes
Whenever you encounter a
SET TOOL
step,
MILLPWR
will display the DRO screen and let
you know which tool to load. If no tool diameter was programmed in the “Tool Step,” you
will be prompted to provide one.
•
Use the
MOVE TABLE
softkey and arrow keys to move the tool
away from your workpiece.
•
Insert the required tool into the spindle.
•
Using the
MOVE TABLE
feature, position the tool over
the surface of a known depth on your workpiece.
•
Press the
DATUM
softkey.
•
Position your tool so that it touches a known surface,
then enter that position into the Z-axis.
•
Press the
USE
key.
•
Raise the tool and press the
GO
key to continue the program.
Clearing the Program
•
From the PGM screen, press the
CLEAR
softkey.
•
Press the
YES
softkey. The PGM screen will be cleared and ready
for another program.
If the surface is
at datum 0, use
the Z = 0 soft-
key.