ACU-RITE MILLPWR 3 Axes - Manual (Page 197)

SETUP
MILLPWR ®
Operation Manual 7-17
Installation Setup
After you’ve selected
“Installation Setup” from the
“Job Setup” list, you will be
asked for a passcode. The
passcode is located on the
page before the table of con-
tents. You can remove it and
store it in a separate location
to prevent accidental or
unauthorized adjustments to
your system. Once you’ve
entered the passcode, the
“Installation Setup” screen
will appear.
Protection
Protection enables you to prevent unauthorized access to your
part programs and tool library. With “Part Program” and “Tool
Library” set to “Yes,” your part programs and tool library cannot
be altered—without first changing your “Part Program” and/or
“Tool Library”setting’s to “No.”
To change your protection settings:
• From Installation Setup, highlight PROTECTION then
press ENTER .
• Use the NO and YES softkeys to disable or enable protection for both the “Part
Program” and “Tool Library.”
• Press the USE key.
• Continue with Setup or press the USE NEW SETTINGS softkey.