Programming, Operation manual – ACU-RITE MILLPWR 3 Axes User Manual
Page 68
PROGRAMMING
MILLPWR
®
Operation Manual
3-32
Starting and Stopping a G-code Program
Always start the program from a place in the program where the feed rate, X-, Y-, and Z-
axis position are known, such as a tool step. Alternate starting points can be programmed
by placing the proper code in the desired locations.
Pressing the
GO
button will cause
MILLPWR
to begin executing the current G-code program.
Always insure the program step highlighted is an appropriate starting point.
When a program is running, pressing the
STOP
button or the remote pendant will cause the
program and all axis motion to pause. Pressing the remote pendant switch again or the
GO
button will cause the program to resume. Pressing the
STOP
button a second time will halt
the program execution.