ACU-RITE MILLPWR 3 Axes - Manual (Page 183)

SETUP
MILLPWR ®
Operation Manual 7-3
To enter a tool into the Tool Library:
• From Setup, highlight “Tool Library” then press ENTER .
• Highlight a blank row in the Tool Library and press ENTER .
• Enter the tool’s diameter.
• Highlight the “Type” field.
• Press the TOOL TYPES softkey.
• Highlight the tool type that describes the tool you’re using.
Press
ENTER .
• Press the USE key.
• Continue with Setup or press the USE NEW SETTINGS softkey.
If you need to,
change the
units (inches or
mm) for the tool
you’re using
before you set
the length.
Using the tool library without repeat-
able tool lengths: