Program steps, Operation manual – ACU-RITE MILLPWR 3 Axes User Manual
Page 115
PROGRAM STEPS
MILLPWR
®
Operation Manual
5-19
•
Enter the Z-axis feed rate.
•
Select a tool offset by pressing the appropriate softkey.
•
Enter the table’s feed rate.
•
If you wish to program a 2
ND
Corner and/or a tilt angle or
would like to program a finish cut, press the
MORE
softkey.
2
ND
Corner
Enter the X- and Y-axes coordinates for the 2
ND
Corner.
(The 2
ND
Corner must be located diagonally across from
the 1
ST
Corner.)
Tilt Angle
Enter the tilt angle.
Finish
Enter a stepover percentage (how much you want your tool to overlap on each
pass).
•
Press the
USE
key.
Note:
If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running your program (refer to Programming a Tool Step).