ACU-RITE MILLPWR 3 Axes - Manual (Page 113)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-17
• For “Direction,” press either the CW softkey for clockwise or the CCW softkey for a
counter-clockwise direction.
• Arrow down and select a tool offset by pressing the appropriate
softkey.
• Enter the table’s feed rate.
• If you need to program a 2 ND Corner, tilt angle and/or finish
cut:
2 ND Corner
Enter the X- and Y-axes coordinates for the 2 ND Corner.
(The 2 ND Corner must be located diagonally across from the
1 ST Corner.)
Tilt Angle
Enter the tilt angle.
Finish
Highlight "Cut" in the“Finish” field. Enter the amount of material to be removed
during the finish cut.
Enter the feed rate for the finish cut.
For “Direction,” press either the CW softkey for clockwise or the CCW softkey for a
counter-clockwise direction.
• Press the USE key.
Note: If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running your program (refer to Programming a Tool Step).