ACU-RITE MILLPWR 3 Axes - Manual (Page 117)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-21
• Enter the slot's width.
• Enter the slot’s length.
• Arrow down and enter the feed rate.
• If you want to program a tilt angle and/or finish cut:
Tilt Angle
You can slant a slot by identifying a tilt angle.
Highlight the “Tilt Angle” field and enter an angle
(measured from the X-axis).
Finish
Enter the amount of material to be during the finish
cut.
Enter the feed rate for the finish cut.
Select the finish cut’s direction. Press the CW softkey for a clockwise direction or
the CCW softkey for a counter-clockwise direction.
Enter a stepover percentage (how much you want your tool to overlap on each pass).
• Press the USE key.
Note: If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running your program (refer to Programming a Tool Step).