Program steps, Operation manual – ACU-RITE MILLPWR 3 Axes User Manual

Page 141

PROGRAM STEPS

MILLPWR

Operation Manual

5-45

•

Highlight "Font.” If you want to change the font, press the

ENGRAVER

FONTS

softkey, highlight the font you want, then press

ENTER

•

Highlight "Modifier” and press either the

NORMAL

MIRRORED

softkey. "Normal" means that the engrav-

ing will be readable from left to right; "Mirrored" will
make the engraving appear backwards.

•

Enter the table’s feed rate.

•

Press the

EDIT TEXT

softkey.

•

Notice that the screen is divided
into two sections— “Text Block”
and “Characters.” You can switch
from one to the other by pressing
either the

TEXT BLOCK

CHAR-

ACTER

softkey. Use the arrow

keys to move around within each
section.

•

In the “Character” section, highlight a letter, number, symbol or space.
Press the

ENTER

key to make a selection. (The alphabet block on the left

side represents capital letters; the block on the right side represents low-
er case letters.)

To add a space, move your cursor to a blank spot anywhere within the
"Characters" box and press the

ENTER

key.

You can edit text by pressing the

TEXT BLOCK

softkey. Highlight the

character you want to edit, and then press one of the following:

The

CLEAR

key will delete a character.

The

DELETE LINE

softkey will erase the entire line of text that the

cursor is in and move all following text lines up.

The

INSERT LINE

softkey will insert a blank text line, moving exist-

ing text lines down.

The

CLEAR ALL

softkey will erase all of the text within the text

block.

Use "mirrored"
if you're making
a mold.