ACU-RITE MILLPWR 3 Axes - Manual (Page 36)

DRO
MILLPWR ®
Operation Manual 2-13
To change the hole pattern size, depth, location, number of holes, etc., press the HOLES
key again. Now press the appropriate softkey, enter the new information and then press
the
GO key .
This also applies to rectangles, circles, lines and arcs. The rectangle and circle milling
functions require you to establish a tool offset. Lines and arcs only require a tool offset
if the tool follows the left or right edge. It’s a good idea to setup the tool before using
either of these function keys. (Refer to Program Steps for a complete description of
each function.)
Note: The “Tool” setting on MILLPWR ’s “Status” bar (located along the top of the
MILLPWR screen) will indicate which tool has been selected. If there’s no tool
identified, or if it’s incorrect, you’ll need to start with a “Set Tool” step that
accurately identifies the tool you’re using (refer to Programming A Tool Step).