ACU-RITE MILLPWR 3 Axes - Manual (Page 129)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-33
To create a hole frame or hole array:
• Press the HOLES key.
• Press the FRAME softkey to program a hole frame;
press the ARRAY softkey to program a hole array.
• Enter the X- and Y-axes coordinates for your 1 ST
corner into the "From" field.
• In the “Size” field, enter the lengths along the X-
and Y-axes.
• Enter the begin and end depths for the Z-axis.
• (Optional) Enter either the number of pecks OR the distance between
each peck.
• Select the DRILL , BORE or POSITION softkey.
• Enter the Z-axis feed rate.
• In the "Holes" field, enter the number of holes you want to include along
the X- and Y-axes.
• If you would like to program a retract, 2 ND corner,
hole spacing and/or tilt angle, press the MORE
softkey.
Tool Retract
Enter either the number of retracts OR the
distance between each retract.
Enter the length of time (in seconds) that you want
the quill to dwell (pause) during each retract.
Drill - The quill
will feed down
then rapidly move
up.
Bore - The quill
will feed down
then feed up.
Position - You will
be prompted to
move the quill
manually.