ACU-RITE MILLPWR 3 Axes - Manual (Page 16)

INTRODUCTION
MILLPWR ®
Axis Conventions
Count Direction
When programming a part using MILLPWR , table movement and tool movement are
determined by the use of positive or negative numbers. MILLPWR has been factory
set with the following positive and negative count
directions for the X, Y and Z-axes:
X-axis: The table will move to the left and the
tool will move to the right for a
positive count direction.
Y-axis: The table will move toward you while
the tool moves away from you for a
positive count direction.
Z-axis: The quill will move up (away from
the table surface) for a positive count
direction.
Operation Manual 1-6
Conventions