ACU-RITE MILLPWR 3 Axes - Manual (Page 40)

PROGRAMMING
MILLPWR ®
If one step follows another, MILLPWR assumes that you want them to be connected. It auto-
matically fills in the “From” point, “Depth,” and “Tool Offset.” All you have to do is fill in
the “To” point and press
USE .
Note: MILLPWR will allow you to program different feed rates within each step of a
continuous contour.
Note: An “X” before or after a step number indicates that the step is invalid. Highlight the
step, press enter and correct the information as needed. Press use when finished.
Operation Manual 3-4
Single lines
indicate an
open-ended
continuous
tool path. Double lines
indicate a
closed con-
tinuous tool
path.