ACU-RITE MILLPWR 3 Axes - Manual (Page 135)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-39
Repeat
Using this step you can repeat whole programs or sections of programs horizontally,
vertically or both.
To program a repeat:
• From the PGM screen, press the MORE STEPS softkey.
• Press the REPEAT softkey.
Tip: Use the TEACH POSITION softkey to indicate
a second.
• Enter the number of the first step and the last step in
the step range that you want to repeat.
• Enter the offset for the X-, Y- and/or Z-axis.
(The offset is the distance between repeats.)
• Enter the number of times you want to repeat the
original steps.
Note: The steps being repeated must precede the “Repeat” step.
Tip: Entering a 0(zero) for the number of repeats will change the location of the
original steps entered in the FROM and TO fields. To shift the datum of an
entire program, place a repeat step at the end of the program and enter the
required coordinate shift(s) in the X-, Y-, and/or Z-axis fields. When USE is
pressed the entireprogram will shift by the entered values.