ACU-RITE MILLPWR 3 Axes - Manual (Page 147)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-51
Chamfer
A chamfer is a bevel or line that’s inserted between two lines to relieve sharp angles
or corners on a part.
You can insert a chamfer between two intersecting lines whose steps are adjacent in
the program step.
There are three ways you can program a chamfer:
• With two lengths
• With Length 1 and an angle
• With Length 2 and an angle
Choose a method based upon information from your print.
You may also close a contour with a chamfer (e.g., a triangle) by inserting the chamfer
step immediately after the last step in the contour.
To program a chamfer:
• From the PGM screen, locate the lines you want to insert a chamfer between.
Highlight the second line.
• Press the MORE STEPS softkey.