ACU-RITE MILLPWR 3 Axes - Manual (Page 58)

PROGRAMMING
MILLPWR ®
Operation Manual 3-22
• Indicate where the directory you want to select is located.
On MILLPWR 's internal memory:
“MILLPWR" and any subdirectories that you have created should appear under
the "DIRECTORY" heading.
On a 3 1 /
2
" floppy disk:
Insert the 3 1 /
2
" floppy disk containing the directory into the floppy disk drive
(located in the lower right-hand corner on the front of the operator console) and
press the
USE FLOPPY softkey. "A:" and any subdirectories you have created
should appear under the "DIRECTORY" heading.
On your PC:
Press the REMOTE STORAGE softkey. "REMTSTOR" and any sub-
directories you have created will appear under the "DIRECTORY"
heading.
• Using the arrow keys, highlight the directory you want to open. (If
the list is long, use the
PAGE UP and PAGE DOWN softkeys to scroll
through the list more quickly.)
• Press the SELECT DIRECTORY softkey again. The "DIRECTORY" list will disappear,
indicating that your directory has been selected.
You can now save your program in the directory you have chosen; or if you prefer, load an
established program from the directory you selected (refer to Program Functions).
The REMOTE
STORAGE soft-
key will only
appear if MILL-
PWR has been
set up for remote
storage.