ACU-RITE MILLPWR 3 Axes - Manual (Page 70)

PROGRAMMING
MILLPWR ®
Operation Manual 3-34
Code Comment
G80 Cancel Motion Mode This command cancels the current motion command mode.
Motion is reset to G1. X, Y, and Z coordinates are reset to no
motion. I, J, and K coordinates are reset to no offset.
G92
Set Offset Mode (ABS)
This command stops the program after completion of the block.
The cursor moves to the subsequent program block. The cur-
rent settings remain in effect.
Program Stop M0
O Program Number
N Line Number
The offset applies to current and subsequent arc blocks (G2 and
G3). The default is offset.
MILLPWR does not support “per revolution” units. G93 or G95 will
generate a run-time error. G 93 & 95 are not supported.
Tool Length Offset (Index) H
I X Axis Offset to Arc Center
G*
These commands set the mode for interpreting coordinates. In
ABS mode, coordinates are relative to MILLPWR’s datum. In INC
mode, coordinates are relative to the tool’s position after complet-
ing the previous move. The setting applies to current and subse-
quent blocks. The default is G90 (ABS).
Set feed/speed units (/sec) G94
Line numbering is optional and for readability only. MILLPWR
does not make use of this information.
G90
G91
Set Offset Mode (INC)
All other G codes not listed will generate a run-time error.
MILLPWR does not support H-code tool length offsetting. The off-
set is retrieved from MILLPWR’s tool library when a tool change
is executed. This command has no effect and is ignored.
J
K
Y Axis Offset to Arc Center
Z Axis Offset to Arc Center
Program number is optional. MILLPWR does not make use of
this information.
Description
M1 Optional Program Stop This command is ignored. MILLPWR does not have a switch for
selecting whether to stop on this command.
These commands set the path mode. The setting applies to cur-
rent and subsequent blocks. The default is G64 (continuous).
MILLPWR does not support presettable work coordinate systems.
Selecting a coordinate system is possible, but setting it (G10 or
G92) will generate a run-time error.
MILLPWR does not support tool length offsetting. The offset is
retrieved from MILLPWR’s tool library when a tool change is exe-
cuted. These commands are ignored. G43 Tool Length Offset (+)
G44 Tool Length Offset (-)
G49 Cancel Tool Length Offset
G54 to
G59
Work Coordinate System
G61 Set “stop” Path Mode
G64 Set “continuous” Path Mode
G81 t O
G89
MILLPWR does not support canned drilling cycles (G81) through
G89). Canned Cycles
G92 is not supported. G92 is not supported.