ACU-RITE MILLPWR 3 Axes - Manual (Page 181)

SETUP
MILLPWR ®
Operation Manual
Setup
Press the SETUP key to access the setup parameters. The setup parameters are grouped into two
categories: Job Setup and Installation Setup.
Job Setup parameters can easily be changed to accommodate specific machining requirements for
each job.
Installation Setup parameters, on the other hand, are established during the initial installation
and, with few exceptions, should not be changed. For this reason, the installation setup parameters
are protected by a passcode. The passcode is located on the page before the table of contents. You
can remove it and store it in a separate location to prevent accidental or unauthorized adjustments
to your system.
To change your setup parameters:
• From Setup, highlight a topic, then press ENTER . Change the settings, then press the
USE NEW SETTINGS softkey to activate them. (Or press the CANCEL CHANGES soft-
key to exit Setup and return to the previous screen without making any changes.)
7-1