ACU-RITE MILLPWR 3 Axes - Manual (Page 226)

TROUBLESHOOTING GUIDE
MILLPWR ®
Operation Manual
Troubleshooting Guide
Introduction
This troubleshooting guide is intended to assist you with diagnosing problems should
you experience any difficulties with your
MILLPWR system.
Using the Table
This troubleshooting guide is arranged in three columns entitled Symptom, Probable
Cause and Recommended Corrective Action. The Symptoms are listed in the order of
most common, easiest to check, and least expensive to correct. First, locate the symptom
that best describes the problem that needs to be corrected. Then, identify the probable
cause that most closely matches the problem that you are experiencing and implement
the recommended corrective action.
This troubleshooting guide pertains to the ACU-RITE MILLPWR system specifically and
on occasion the machine tool itself. It does not fully address problems associated with
inadequate tooling, improper feed rates and/or spindle speeds, etc.
Note: This troubleshooting guide has been written with the understanding that your
ACU-RITE
MILLPWR system has been properly installed by a factory-trained
and certified technician.
9-1
Do not attempt to make any repairs to the operator console and/or
motor assemblies on your own. Please contact your ACU-RITE
distributor for repair and/or replacement assistance.
IMPORTANT