Log display – 3Com 3500 User Manual
Page 749
log display
749
✓
3500
9000
9400
3900
9300
log display
Displays the current log settings.
Valid Minimum Abbreviation
log di
Important Consideration
■
The CoreBuilder 3500 by default enables logging to the serial port
session and disables logging to any Telnet or modem session.
However, you can toggle the current logging state on the
CoreBuilder 3500 from serial port to Telnet or modem by entering
Ctrl+L.
Fields in the Log Display
Field
Description
consoleOut
Administration Console output device. You can enable or
disable the Console to display event log messages for each
severity level.
Logging message
Whether logging to this console session is enabled or
disabled.
Supported Event Log Services
AppleTalk
Appletalk log service.
Enabled
or
disabled
for each
severity level.
IPX
IPX log service.
Enabled
or
disabled
for each severity
level.
System
System log service.
Enabled
or
disabled
for each
severity level.
Severity Levels
Config
Configuration changes.
Error
Application-specific error. Default:
enabled
Info
Severity level of changes in the state of the system that are
not caused by events at any other severity level
Warning
Nonfatal problem. Default:
enabled