3Com 3500 - Manual (Page 404)

404 C HAPTER 16: I NTERNET P ROTOCOL (IP)
Options
Prompt Description Possible Values [Default]
IP address IP address of the interface, chosen
from the range of addresses that
the central agency assigned to your
organization. This address is specific
to your network and system. A valid IP address
in the range of
addresses that
are assigned to
your
organization –
Subnet mask 32-bit number that uses the same
format and representation as an IP
address. The subnet mask
determines which bits in the IP
address are interpreted as the
network number, the subnetwork
number, and the host number.
Each IP address bit that corresponds
to a 1 in the subnet mask is in the
network/subnetwork part of the
address. Each IP address bit that
corresponds to a 0 is in the host
part of the IP address. A valid subnet
mask in
accordance with
the bits that are
used for network
number,
subnetwork, and
host number Depends
on
specified IP
address
Interface type Whether to use router port-based
routing or VLAN-based routing.
■
port
■
vlan
vlan
VLAN mode
(for router
port-based
routing) Whether the system removes all
VLANs and recreates the default
VLAN to enable port-based routing.
■
n (no)
■
y (yes)
y
Bridge port (for
router
port-based
routing) Port to use for port-based routing
(may designate only one port).
■
1 – n
■
? (for a list of
selectable
ports)
–
VLAN interface
index (for
VLAN-based
routing) Index number of the IP VLAN that is
associated with the IP interface; for
a VLAN-based IP interface, you
must assign this number. (Not
applicable if you have more than
one VLAN)
■
A selectable
VLAN index
■
? (for a list of
selectable
VLAN
indexes)
Next
available
index
number