3Com 3500 - Manual (Page 458)

458 C HAPTER 16: I NTERNET P ROTOCOL (IP)
ip rip
routeAggregation
✓
3500
✓ 9000
9400
3900
9300
Mode
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Sets the route aggregation mode.
Valid Minimum Abbreviation
ip ri ro
Important Considerations
■
Route aggregation mode determines which route table entries are
sent during a RIP Version 2 update.
■
If route aggregation mode is
enabled
, RIP-2 can function like RIP-1
and “collapse” route table entries for all subnets of a directly
connected network. For example, if route aggregation is
enabled
,
and the system is advertising subnets 150.100.31.0 and
150.100.32.0, only the entry for network 150.100.0.0 is sent in
the update. With RIP Version 2, you must enable route aggregation
mode if you want the interface to collapse the route table entries
and function like RIP-1.
■
If route aggregation mode is disabled (the default), a RIP-2
update sends all routing table entries.
Options
Prompt Description Possible Values [Default]
IP interfaces Index number of the interfaces
for which you want to set the
route aggregation mode
■
One or more
selectable
interface indexes
■
all
■
? (for a list of
selectable
interface indexes)
Previous
entry, if
applicable
Route
aggregation
mode Whether you want to
implement route aggregation
on the selected interface
■
disabled
■
enabled
Current
value