3Com 3500 - Manual (Page 407)

ip interface modify 407
✓ 3500
✓ 9000
✓ 9400
✓
3900
✓
9300
ip interface modify For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Changes the configuration of an interface that you have already defined.
Valid Minimum Abbreviation
ip i m
Important Consideration
■
On the CoreBuilder 3500, you cannot modify the port number (router
port-based routing) after it has been defined because of the
associated virtual LAN (VLAN); you must remove the interface and
then redefine it.
Options
Prompt Description Possible Values [Default]
IP interface Index number that is associated
with the interface that you want
to modify.
(Not applicable if you have more
than one interface)
■
A selectable IP
interface index
■
? (for a list of
selectable
indexes)
Current
value
IP address IP address of the interface that
you want to modify. A valid IP address
in the range of
addresses that are
assigned to your
organization Current IP
address
Subnet mask Subnet mask for the interface
that you want to modify. A valid subnet
mask in
accordance with
the bits that are
used for network
number,
subnetwork, and
host number Current
subnet
mask
VLAN interface
index (for
VLAN-based
routing) Index number of the IP VLAN
that is associated with the IP
interface; for a VLAN-based IP
interface, you must assign this
number.
(Not applicable if you have more
than one VLAN)
■
A selectable
VLAN index
■
? (for a list of
selectable
VLAN indexes)
Current
value