3Com 3500 - Manual (Page 453)

ip rip mode 453
✓ 3500
✓ 9000
✓ 9400
✓
3900
✓
9300
ip rip mode For CoreBuilder 9000: Applies to Layer 3 switching modules only.
On a per-interface basis, sets one of four RIP Version 1 (RIP-1) modes on
the system. For all platforms except the CoreBuilder 9000, also allows you
to set RIP Version 2 (RIP-2) modes.
Valid Minimum Abbreviation
ip ri m
Important Considerations
■
Platforms except the CoreBuilder 9000 support RIP Version 1 as well
as RIP Version 2. For each interface, you select a RIP Version 1 mode
and a RIP Version 2 mode. The default RIP Version 1 mode for all
platforms is
learn . The default RIP Version 2 mode is learn .
■
The four available RIP modes are as follows:
■
Disabled — The interface ignores all incoming RIP packets and
does not generate any RIP packets of its own.
■
Learn — The interface processes all incoming RIP packets, but it
does not transmit RIP updates. This is the default RIP mode.
■
Advertise (3500 and 9000 only) — The interface broadcasts RIP
updates, but it does not process incoming RIP packets.
■
Enabled (3500 and 9000 only) — The interface broadcasts RIP
updates and processes incoming RIP packets.
Options
Prompt Description Possible Values [Default]
IP interfaces Index number of the interfaces
for which you want to set the RIP
mode
■
One or more
selectable
interface
indexes
■
all
■
? (for a list of
selectable
interface
indexes)
Previous
entry, if
applicable