3Com 3500 - Manual (Page 420)

420 C HAPTER 16: I NTERNET P ROTOCOL (IP)
✓ 3500
✓ 9000
✓ 9400
✓
3900
✓
9300
ip route display For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Displays the system’s routing table to determine which routes to other IP
networks are configured and whether the routes are operational.
Valid Minimum Abbreviation
ip route di
Important Considerations
■
For the CoreBuilder 3500 only, the system prompts you for an IP
address and subnet mask. As a result, you can display only a subset of
routes instead of all routes. To see all entries in the table, simply press
Enter at these prompts.
■
The first line in the output (the status line) indicates whether IP routing
is enabled:
■
For the CoreBuilder 9000 Layer 3 module, it also indicates whether
Internet Control Message Protocol (ICMP) router discovery is
enabled on the system.
■
For the CoreBuilder 3500, IP interface options (such as ICMP router
discovery) appear under “ip interface detail” earlier in this chapter
and are set on a per-interface basis.
Options (3500 only)
Prompt Description Possible Values [Default]
IP address IP address (and its
corresponding
subnet mask) for
which to display only
those routes that
match the bits set
in it
■
A valid IP address
■
0.0.0.0 (displays all
entries)
0.0.0.0
Subnet mask Subnet mask for the
specified IP address
for which to display
only those routes
that match the bits
set in it A valid subnet mask of a
specified IP address Current
value