3Com 3500 - Manual (Page 703)

qos classifier modify 703
Procedure (Flow Classifier)
1 Enter the number of the classifier that you want to modify. The current
numbers are shown in braces { }.
2 To modify the name, enter the new name for the classifier.
The name that is associated with the classifier number that you specified
is shown in brackets.
Start and end
of TCP or UDP
destination
port range For flow classifiers only,
start and end of the TCP
or UDP destination port
range.
Specify as small a range
as possible. The start
value determines the
end value.
0 – 65535 0 and
65535
(factory
defaults),
or current
values
Additional
filters
(address/port
patterns) For flow classifiers only,
additional source,
destination, and port
information for this
classifier. Each set of
information counts
toward the classifier
limit.
■
y (yes)
■
n (no)
no (factory
default)
Custom
protocol type
(custom
nonflow
classifiers only) For nonflow classifiers
with the custom
protocol type.
■
Ethertype
■
DSAP/SSAP
–
Custom
protocol
hexidecimal
value (custom
nonflow
classifiers only) Hex values for nonflow
classifiers with the
custom protocol type.
■
Ethertype hex value
of 0x0 – 0xffff
■
DSAP hex value of
0x0 – 0xff
■
SSAP hex value of
0x0 – 0xff
0x0
–
0x0
802.1p tag For nonflow classifiers
only, the IEEE 802.1p
tag value
■
Any combination of
priority tag values in
the range of 0 – 7
■
all
■
? (for a list of
selectable values)
Current
value, if
any
Prompt Description Possible Values [Default]