3Com 3500 - Manual (Page 513)

ip multicast dvmrp tunnels remove 513
ip multicast dvmrp
✓
3500
✓
9000
9400
3900
9300
tunnels remove
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Deletes a DVMRP tunnel end point from the system.
Valid Minimum Abbreviation
ip m d t r
Important Considerations
■
To remove a tunnel, specify its tunnel index number. This number is
different from the routing interface index number. Reference the
DVMRP tunnel summary display prior to deleting a tunnel.
■
If you try to remove an IP interface in your system, and you have a
DVMRP tunnel defined on that interface, the system warns you with
an error message. Before you can remove the IP interface, you must
remove the DVMRP tunnel.
■
When you remove a tunnel, the system does not dynamically re-order
remaining tunnels in the DVMRP tunnel summary display. For
example, if you had three tunnels with tunnel index numbers 1, 2, and
3 and you then removed tunnel 2, the display lists the remaining
tunnels with their original tunnel index numbers (1 and 3, in this
example). The system assigns tunnel index 2 to the next new tunnel
that you define. After 2 is used, the system can assign tunnel index 4
for the next new tunnel, and so on.
Options
Prompt Description Possible Values [Default]
Multicast
tunnel index Index number of the
multicast tunnel that you
want to remove from the
system
■
A valid DVMRP tunnel
index number
■
? (for a list of selectable
tunnel index numbers)
–