3Com 3500 - Manual (Page 697)

qos classifier define 697
Flow Classifier Procedure
To accept the default or current values that appear in brackets [ ], press
Enter.
1 Enter a classifier number in the range of from 1 through 399 .
Flow classifiers 20 and 23 are predefined for FTP and Telnet.
2 Enter the classifier name (a unique name of up to 32 characters).
3 Enter a cast type.
For a flow classifier, the options are unicast , multicast , and all .
4 Enter the IP protocol type of TCP , UDP , or all .
5 Enter the source IP address. The default value is 0.0.0.0 .
6 Enter the source IP address mask. The default value is 0.0.0.0 .
7 Enter the destination IP address.
8 Enter the destination IP address mask.
9 Enter the start of the TCP or UDP source port range, in the range of from
0 through 65535 . The default is 0 .
10 Enter the end of the TCP or UDP source port range using a value of up to
65535 .
Custom
protocol
hexidecimal
value (custom
nonflow
classifiers only) Hex values for
nonflow classifiers
with the protocol
custom type
■
Ethertype hex value of
0x0 – 0xfffe
■
DSAP hex value of
0x0 – 0xff
Note: You cannot enter
0xaa - 0xaa
■
SSAP hex value of
0x0 – 0xff
Note: You cannot enter
0xaa - 0xaa
0x0
–
0x0
802.1p tag For nonflow
classifiers only, IEEE
802.1p tag values
■
Any combination of
priority tag values in the
range of
0 – 7
■
all
■
? (for a list of possible
values)
–
Prompt Description Possible Values [Default]