Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 907)

Viewing Configuration Parameters for the WSX
Page 29-35
Viewing Virtual Circuit Parameters
To view virtual circuit parameters, enter the following command
frview //
where is the slot number where the WSX board is located, is the port number on
the WSX board, and is the number used to identify the virtual circuit that you want to
view. For example, if you wanted to view configuration parameters for DLCI 17 on Port
number 1 of the WSX board in switch slot 3, you would enter
frview 3/1/17
or
frv 3/1/17
A screen similar to the following displays:
Frame Relay DLCI for Slot 3, Port 1, DLCI 17.
1) Administrative State ..................................................... = UP
2) Committed Information Rate (CIR) in BPS ..................... = 16000
3) Committed Burst Rate(Bc) in bits ................................. = 16000
4) Excess Burst Rate(Be) in bits........................................ = 40000
5) Compression Administrative Status .............................. = Enabled
6) Compression PRetry Time ............................................ = 3
7) Compression PRetry Count .......................................... = 10
8) Fragmentation Interleaving .......................................... = Enabled
81) Fragmentation Size .................................................. = 53
This screen lists all the current values for the listed parameters. These parameters are the
same ones set through the
frmodify command. For detailed information on these values, see
Modifying a Virtual Circuit on page 29-29.