Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 1020)

Backup Services Commands
Page 34-10
Modifying a Frame Relay PVC Backup Service
To modify a backup service for a frame relay PVC:
1. First, enter the bsmodify command, followed by the index of backup service, followed by
, as shown in the example below:
/Interface/backup % bsm b2
A screen similar to that shown below will display:
1) Description : Backup 1
2) Admin Status { (E)nabled, (D)isabled } : Enabled
Primary Type : Frame Relay PVC
Slot : 3
Port : 3
DLCI : 32
Backup Type : PPP Peer
Peer ID : 1
5) Startup Timer Value {Time in Seconds after
System Startup to wait
for Primary to come up
before activating
Backup }
: 300
6) Activate Timer Value (Time in Seconds after
Primary Failure to
activate Backup }
: 10
7) Restore Timer Value {Time in Seconds after
Primary restoral to
disable Backup }
: 10
(save/quit/cancel)
:
The command functions in a manner similar to the create command, except the parame-
ters that define the backup service may not be changed. These parameters are the:
• index
• primary type
• primary type subparameter
• backup type, and
• backup type subparameters.
Only the Description and Timer fields may be modified.
2. Once you are satisfied with the values, enter the save command, followed by at
the prompt, as shown below:
: save
A screen similar to that shown below will display:
Backup Service Index 2 modified.
/Interface/backup %