Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 1052)

Running Hardware Diagnostics
Page 36-14
The tests are complete at this point. A summary of the test results and failures is displayed at
the end of the test sequence. In this example, the module passed all tests except the port test.
The ESX-K-C-32 module in slot 3 should have a red
OK2 LED to indicate diagnostics failure.
And the Failure Summation section displays only the first three failures when you request
multiple test iterations.
You should now disconnect the cables used in the external loopback tests. Press and
the module will be restored to its normal, pre-testing state. The OK2 LED will remain red until
the module is reset or the chassis is rebooted.
The main system command prompt re-displays.