Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 614)

Port Mapping
Page 19-72
Viewing a Port Mapping Set
You can view a port mapping set using the vpmap command. Enter the pmapv command as
shown:
pmapv
where is the map set number shown when the map set was created. For example,
to modify map set 5, you would enter the following:
pmapv 5
The following screen is shown:
Port Mapping Configuration
=======================
Port Map Id Ingress Ports Egress Ports
----------------- ------------------- ------------------
5 3/1, 3/2, 3/3 4/1, 4/2, 4/3
As a variation of this command, enter the vpmap command with no port map identification.
This will display all port mapping sets configured for this switch.
Port Map Id . An identification number for the port map set, generated when the set is created.
Ingress Ports . The switch ports designated as ingress ports for this port map set. Ingress ports
can only communicate with egress ports.
Egress Ports . The switch ports designated as egress ports for this port map set. Egress ports
can only communicate with ingress ports.
Deleting a Port Mapping Set
You can delete a port mapping set after it is created. Enter pmapdel at a prompt as shown:
pmapdel
where is the map set number shown when the map set was created. (To view a list
of all existing map sets, see Viewing a Port Mapping Set on page 19-72.) For example, to
modify map set 5, you would enter the following:
pmapdel 5