Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 864)

The WAN Port Software Menu
Page 28-38
Obtaining Status and Statistical Information
You can obtain general and detailed WAN port statistical information on all WSX boards in the
switch, a single WSX board, individual ports, and Frame Relay and PPP protocols. The
wpstatus command is used to provide this information. This information includes types of
physical interface, access rate of the Frame Relay line, and errors. In addition, the wpstatus
command can display the number of frames received and transmitted.
Obtaining Information on All Boards in a Switch
To obtain status information on all WSX boards in a switch, you enter the wpstatus command
without any parameters as follows:
wpstatus
or
wps
This command displays a screen similar to the following (In this example, the port parameters
being displayed are for a system that contains a 2-port
WSX -BRI module in slot 4, an 8-port
WSX module in slot 5, and a 2-port WSX in slot 8.):
Admin/
Oper/
Speed Utilization
Slot/Port PortType Intf. Type State Protocol BPS Clocking 10s 1m 5m
======= ======== ======= ====== ======= ======== ======== ==== ==== ====
4/1 Serial *NONE* UP/DN FR EXT CLK External 10% 10% 10%
4/2 ISDN ISDN-ST UP/DN PPP N/A External 40% 30% 60%
5/1 Serial V35DCE UP/UP PPP 2048000 Split 30% 60% 50%
5/2 Serial V35DCE UP/UP FR 2048000 Split 100% 50% 70%
5/3 Serial X21DCE UP/DN FR 2048000 Split 90% 80% 60%
5/4 Serial V35DCE UP/UP FR 2048000 Split 20% 50% 50%
5/5 Serial *NONE* UP/DN FR EXT CLK External 30% 30% 50%
5/6 Serial *NONE* UP/DN FR EXT CLK External 100% 50% 80%
5/7 Serial *NONE* UP/DN FR EXT CLK External 70% 50% 50%
5/8 Serial *NONE* UP/DN FR EXT CLK External 100% 80% 30%
8/1 T1 T1 UP/UP FR 1544000 External 80% 50% 70%
8/2 Serial 530DCE UP/UP FR 2048000 Split 10% 50% 40%
Each row in the table corresponds to a physical port on a WSX board in the switch. The
following sections describe the columns shown in this table:
Field Descriptions
The following section explains the fields and their corresponding values.
Slot/Port
The first number in this column is the slot in the switch where this WSX is installed. The
second number is the port number on the WSX .
Port Type
This column shows
• Serial
• ISDN
• T1
• E1