Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 238)

Clearing System Statistics
Page 9-16
Clearing System Statistics
You may want to clear statistics for a specific module, port or service for dialogistic or
accounting purposes. To clear switch statistics enter
clearstat
at the system prompt. A screen similar to the following will display.
Usage: clearstat slot [,port] [,service] [,instance]
As indicated in the prompt, you can clear all statistics from a module by entering the slot
number as shown here:
clearstat 3
This entry will clear all statistics for the module located in slot 3. If you want to clear statistics
for a specific port, service or instance, enter the
clearstat command followed by the appropri-
ate numbers. You must use a comma ( , ) to separate the slot number from the port, service
and instance numbers. The following command will clear all statistics for port 1 of the
module located in slot 3.
clearstat 3,1
♦ Caution♦
When the clearstat command is used, no notification is
sent to the SNMP manager about the cleared statistics.
Use of this command can cause unpredictable results
with your NMS statistics.