Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 493)

Configuring Source Route to Transparent Bridging
Page 17-45
6. Once you have selected the frame type, you are returned to the menu prompt. By reenter-
ing the srtbcfg command as you did in step 1, you can now see that SRTB has been acti-
vated for group 1, as shown:
Group 1: SRTB is ON
Default Explorer: STE Ethernet Ring ID: 871(x321)
Group 2: SRTB is ON
Default Explorer: STE Ethernet Ring ID: 291(x123)
Group 3: SRTB is ON
Default Explorer: ARE Ethernet Ring ID: 561(x231)
The ring ID and default explorer frame are shown as well.
Disabling SRTB for a Group
To turn SRTB off for a group, enter the srtbcfg command as shown
srtbcfg
where is the number of the group for which you want to disable SRTB. For
example, to disable SRTB on Group 3, you would enter:
srtbcfg 3
The following prompt appears:
Group 3: SRTB is ON
Default Explorer: ARE Ethernet Ring ID: 561(x231)
Would you like to turn off SRTB ? (n) :
Enter y to disable SRTB. Once you have done this you are returned to the system prompt. To
view the changes to the group, enter the srtbcfg command to display a screen similar to the
following:
Group 1: SRTB is ON
Default Explorer: STE Ethernet Ring ID: 871(x321)
Group 2: SRTB is ON
Default Explorer: STE Ethernet Ring ID: 291(x123)
Group 3: SRTB is OFF