Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 692)

Creating a VLAN for Banyan Vines Traffic
Page 22-32
8. The following prompt displays:
Select Protocol:
1. IP
2. IPX
3. DECNET
4. APPLETALK
5. Protocol specified by ether-type
6. Protocol specified by DSAP and SSAP
7. Protocol specified by SNAP
Enter protocol type (1):
Enter a 5 to define a protocol by ether-type and press .
9. The following prompt displays:
Enter the Ether-type value in hex:
10. Enter 0bad as the Ether-type value for Ethernet II encapsulation.
11. The following prompt displays:
Configure more rules for this vlan (y/n):
Enter a Y . You still need to set up rules for LLC and SNAP traffic.
12. The following prompt displays:
Select rule type:
1. Port Rule
2. MAC Address Rule
3. Protocol Rule
4. Network Address Rule
5. User Defined Rule
6. Binding Rule
7. DHCP PORT Rule
8. DHCP PORT Rule
Enter rule type (1):
Press 3 and press .
13. The following prompt displays:
Set Rule Admin Status to ((e)nable/(d)isable):
Type e to enable this rule.
14. The following prompt displays:
Select Protocol:
1. IP
2. IPX
3. DECNET
4. APPLETALK
5. Protocol specified by ether-type
6. Protocol specified by DSAP and SSAP
7. Protocol specified by SNAP
Enter protocol type (1):
Enter a 6 to define a protocol by DSAP and SSAP and press .