Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 455)

Selecting a Default Group
Page 17-7
Selecting a Default Group
Most commands in the Bridge Management Menu allow you to specify a group when
entering the command at the system prompt. If you do not specify a group when entering a
command, the bridge operations are performed on the currently selected group.
♦ Note ♦
You can view the current groups in the switch by
entering
gp at any prompt.
To select a group, enter the selgp command as follows:
selgp
where is the number of the group you wish to modify or view. For example,
to select Group 2 you would enter selgp and the number 2 as shown:
selgp 2
A message confirming the selection of the new group ID followed by the group description.
Group number: 2 is now selected (New GROUP (#1)).
Using the + or - to Change Groups
At any time from the system prompt, you can select a different group by typing a plus ( + ) to
move up one group, or a minus ( - ) to move back one group. For example, if you are
currently working on Group 4 and wish to change to Group 3, you would enter a - at the
system prompt. The following message displays to confirm the change:
Currently GROUP 3 is selected (New GROUP (#3))