Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 421)

Configuring Kodiak Ethernet Ports
Page 15-7
Configuring Kodiak Ethernet Ports
The 10/100cfg command allows you to configure the link mode (full or half-duplex) for ports
on newer Kodiak Ethernet modules.
This procedure describes how to configure Ethernet modules on the Omni Switch/Router.
Follow these steps to configure a Kodiak Ethernet port:
1. Enter 10/100cfg at the system prompt and press .
2. The system displays a prompt asking for the slot and port number:
Enter Slot/Interface :
Enter the slot number, a slash (/), and the port number of the Ethernet port that you want
to configure. Press
.
3. The following prompt displays, showing the current link mode:
Link Mode [Full, Half] (Currently (H)alf Duplex) :
Enter F to set the port to full-duplex mode or H to set the port to half-duplex mode. In
full-duplex mode, the full 100 or 10 Mbps of bandwidth is used for data traveling on each
direction of the cable. Press
after you enter the Mode. The new mode will take
effect; no reboot is required.