Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 260)

Configuring the Syslog Parameters
Page 10-4
Override internals
This field will force all syslog messages to use the default priority mask specified instead
of their own predefined priority masks.
Display internals
This field allows the user to display the task log level. Enter 52=yes to display the sub-
menu below. If, for example, you wanted to change the priority mask CM via kern from
“warn” to “alert,” you would enter 4=alert . Note that this change will take place immedi-
ately and you do not need to enter save for it to take effect. Type save , quit , or cancel and
then press to return to the main syslog menu.
Internal task syslog configuration:
(NOTE: changes take effect immediately and
are NOT saved across reboots!)
0 )
PPM via kern - alert
1 ) LPM via kern - alert
2 ) VPM via kern - alert
3 ) SNMP via kern - alert
4 ) CM via kern - warn
5 ) ATMmgr via kern - alert
6 ) atmLANE via kern - alert
7 ) Q93bif via kern - alert
8 ) ILMIif via kern - alert
9 ) SSI0 via kern - alert
10) atmSNMP via kern - alert
Console logging
Determines whether or not you want to see syslog messages on your console (terminal). If set
to yes, the messages will be displayed on either an
ASCII terminal connected to the console
port or via a Telnet session.
Syslog Priority Codes
Level Value Meaning
LOG_EMERG 0 FATAL system event
LOG_ALERT 1 FATAL subsystem event
LOG_CRIT 2 Problem, subsystem unstable
LOG_ERR 3 Problem, bad event,
recoverable
LOG_WARNING 4 Unexpected, non-fatal event
LOG_NOTICE 5 normal but significant
condition
LOG_INFO 6 info
LOG_DEBUG 7 Internal debug messages