Alcatel Carrier Internetworking Solutions Omni Switch/Router User Manual

Page 626

Defining and Configuring AutoTracker Policies

Page 20-10

Protocol Specified by Ether-Type

a. To specify a protocol by Ethernet type, enter

at the

Select Protocol:

menu. The follow-

ing prompt displays:

Enter the Ether-type value in hex:

b. Enter the desired Ethernet type in hex. You must enter two bytes of data. For exam-

ple, enter 0800 to specify

or enter 0806 to specify

ARP

. All devices that use the

specified Ethernet type will be members of the mobile group or AutoTracker

VLAN

c. Go on to Step 4 below.

Protocol Specified by DSAP and SSAP

a. To specify a protocol by

SAP

(service access protocol) header, enter

at the

Select

Protocol:

menu. The following prompt displays:

Enter the DSAP value in hex:

b. Enter the destination service access protocol (

DSAP

) value in hex and press

The following prompt displays:

Enter the SSAP value in hex:

c. Enter the source service access protocol (

SSAP

) value in hex. Each entry must consist

of one byte of data. All devices that use the specified source and destination

SAP

types

will be members of the mobile group or AutoTracker

VLAN

d. Go on to Step 4 below.

Protocol Specified by SNAP

a. To specify a protocol by

SNAP

(sub-network access protocol) type, enter

at the

Select

Protocol:

menu. The following prompt displays:

Enter the SNAP value in hex

b. Enter the desired

SNAP

value in hex. You must enter five bytes of data. For example,

enter

0000008137

to specify

IPX SNAP

or enter

00000080F3

to specify AppleTalk

ARP

SNAP

. All devices that use the specified

SNAP

type will be members of the mobile

group or AutoTracker

VLAN

c. Go on to Step 4 below.

4. The following prompt displays:

Configure more rules for this vlan (y/n):

You can set up multiple rules for the same mobile group or AutoTracker

VLAN

. Enter a

here if you want to set up more rules in addition to the protocol rule specified here. If
you enter

, you will be prompted for the next rule that you want to set up. Follow the

directions in the appropriate section to configure that rule.

If you enter

, you will receive a message, similar to the one below, indicating that the

VLAN

was set up.

VLAN 1:2 created successfully

You are done setting up rules for this mobile group or AutoTracker

VLAN