Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 1057)

Running Frame Fabric Tests on Omni Switch/Routers
Page 36-19
Test Coverage:
All Fabric Inputs/Outputs not tested:
Fabric in slot 2 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 3 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 4 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 5 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 6 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 7 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 8 (ESX-C12) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Fabric in slot 9 (ESX-C32) has 9 inputs (0-8) and 1 output (0)
All inputs tested
All Outputs tested
Completed: WED OCT 28 16:24:04 2000
If you need to halt the framefab tests, press CTRL-C . This key sequence pauses the testing and
provides a test summary report. You will be prompted to restart the testing after the pause.
♦ Note ♦
During certain phases of diagnostic testing, the CTRL-C
will not be immediately processed. This delay may last
several seconds, or longer.
If your chassis is not fully loaded, the framefab test will report that the frame fabric in the
empty slot was not tested.