Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 278)

View Port-Level Statistics
Page 11-8
For descriptions of the statistics, see View Switch-Level Statistics on page 11-6.
♦ Note ♦
The CPU and memory resources are not applicable to
the module level statistics display, and therefore are not
shown.
View Port-Level Statistics
To view port-level statistics, type the hpstat command at a system prompt as shown:
hpstat /
where is the slot number and is the port number. For example to view port 1 on
slot 3, enter the following:
hpstat 3/1
The following screen is displayed:
Port 3/1 1 Min 1 Hr 1 Hr
Resources Limit Curr Avg Avg Max
------------------ -------- ------- -------- ------- -------
Receive 80 00 00 00 00
Transmit/Receive 80 92* 00 00 00
Backplane 80 00 00 00 00
/System/Health %
Statistics are displayed as percentages of the total resource capacity, and represent data taken
from the last sampling interval. If a threshold for a resource was exceeded, then that statistic
is marked with an asterisk (*). For descriptions of the monitored resources, see Setting Band-
width Thresholds on page 11-3 and Setting Miscellaneous Thresholds on page 11-4 above.
For descriptions of the statistics, see View Switch-Level Statistics on page 11-6.
Reset Health Statistics
To reset the health statistics for the switch, type the hreset command at a system prompt. The
following message is displayed:
Are you sure you want to reset health statistics? (n) :
To confirm your choice to clear the switch health statistics, type y at the prompt. After you
confirm your choice, the following confirmation notice is displayed:
RESET HEALTH STATISTICS
♦ Note ♦
The hreset command clears the statistics for the entire
switch. You cannot clear statistics for the module or
port level only.