Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 809)

Configuring IPX RIP/SAP Filtering
Page 27-21
7. The following prompt displays:
IPX node mask (default: all F's) :
Enter the IPX node mask (in hexadecimal format) to be used (or just press to use
the default mask of all F's). If you selected the default of “all nodes” in the previous step,
this step is skipped.
8. The following prompt displays:
SAP service type (default: all services) :
Enter the SAP service type (in hexadecimal format) as defined by NetWare (or just press
to use the default of all services).
9. A message will confirm the addition of the filter:
ipxfilter successfully added
Using Filters with Frame Relay or ISDN Boards
If the Group or VLAN you enter (such as 1:1 used in the above example) refers to a WAN
interface like Frame Relay or PPP, you’ll be asked if you want the filter applied to a specific
WAN endpoint.
10. This prompt appears after the previous prompt for “SAP Service Type”:
Do you wish to apply this filter to a specific WAN endpoint? (n):
Enter y to select to apply this filter to a specific WAN endpoint.
11. The following prompt displays:
Frame Relay VC or PPP Peer {vc(v), peer(p)} (v):
Enter v (or just press ) to apply this filter to a Frame Relay Virtual Circuit. Proceed
to the next step.
Enter p if you want to apply this filter to a PPP Peer. Skip to the last step.
12. If you chose to apply a filter to a Frame Relay VC, this prompt displays:
Slot/port:
Enter the slot and port to which you want to apply this filter (for example, 3/1 ).
Enter the VC to which you want to apply this filter.
13. If you chose to apply a filter to a PPP Peer, this prompt displays:
Peer ID:1
Enter the Peer ID to which you want to apply this filter (for example, 1 ).