Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 906)

Viewing Configuration Parameters for the WSX
Page 29-34
Viewing Port Parameters
To view port parameters, enter the following command
frview /
where is the slot number where the WSX board is located, and is the port
number on the WSX board on which you want to view information. For example, if you
wanted to view configuration parameters for Port number 1 on the WSX board in slot 2, you
would enter
frview 2/1
or
frv 2/1
A screen similar to following displays:
Frame Relay port for Slot 2, Port 1.
1) Description................................................................... = Port1
2) Administrative Status .................................................. = UP
3) DLCMI Type.................................................................. = ANSI T1.617 Annex D
31) DLCMI Type ........................................................... = User
4) Poll Verification Interval T392 (seconds ) ...................... = 15
5) Full Status Interval N391/nN1 ....................................... = 6
6) Error Threshold N392/nN2............................................ = 3
7) Monitored Events Counter N393 ................................... = 4
8) Default Bridging Group ................................................ = 1
9) Default Frame-Relay Bridging Mode ............................. = Bridge All
10) Default Routing Group ................................................ = 0
11) Default Compression Admin Status............................. = Enabled
12) Default Compression PRetry Time .............................. = 3
13) Default Compression PRetry Count ............................. = 10
This screen lists all the current values for the listed parameters. These parameters are the
same ones set through the
frmodify command. For detailed information on these values, see
Modifying a Port on page 29-22.