Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 659)

GMAP
Page 21-13
Displaying GMAP Statistics by MAC Address
To display GMAP statistics for all MAC addresses, use the gmapls command. The screen
displays similar to the following:
GMAP Table
================
MAC Address Protocol Group Src Switch ID Flags Timeout(sec)
------------------------ ------------- ----------- ------------------------ ---------------- --------------------
000502:C07F11 1809B 12 0020DA:ECC770 00:00:00:00 3536
800 12 0020DA:ECC770 00:00:00:00 3536
00105A:1873B9 1809B 12 0020DA:ECC770 00:00:00:00 3536
800 23 0020DA:ECC770 00:00:00:00 3536
To limit the display, specify the MAC address. For example:
gmapls 00105A:C07F11
Fields in this table are defined as follows:
MAC Address . The MAC address of the local end station.
Group . The group(s) to which the MAC address belongs.
Protocol . The protocol associated with the group on the switch from which the information
was received. Protocol values are defined as follows:
• e0e0 or ffff — IPX over 802.3
• 8137 — IPX over Ethernet II
• 18137 — IPX over SNAP
• 28137 — any IPX encapsulation
• 800 — IP
• 809b — AppleTalk
• 1809b — AppleTalk over SNAP
• 6003 — DECNET
Src Switch ID . The MAC address of the switch from which the entry was received.
Flags . The first two bytes are not used. The third byte displays the AutoTracker flags associ-
ated with the entry on the source switch. The last byte displays the router flags associated
with this entry on the source switch.
Timeout (sec) . The number of seconds remaining until this entry is deleted (unless another
GMAP message is received and then the entry is refreshed).