Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 784)

Generic Service UDP Relay
Page 26-20
Forward to VLANs
Use this parameter to list, add, or delete VLANs to which the NBNS UDP relay will forward.
This default is UNSET . This value redisplays as SET when at least one VLAN is configured. Up
to 32 VLANs may be configured. You can list forwarding VLANs , or add or delete VLANs from
the forwarding list by entering 434=l , 434=a , or 434=d on the command line.
To configure a generic service:
1. On the Add new Generic Service menu, enter a description of the generic service. For
example:
431=TFTP
2. Enter the relevant UDP port number. For example:
432=69
3. At least one next-hop address must be configured. To add an address, enter:
433=a
The screen displays similar to the following:
FORWARD TO Server List
Item Server address Server Name (if known)
Enter IP address or host name of server to be added to list [‘h’ for help/ to exit]:
4. Enter the next-hop address in dotted decimal format (i.e., 198.206.181.12), a hexadecimal
address (i.e., 0xc6ceb501). A host name (i.e., system.com) may be entered if the DNS
resolver is enabled using the res command.
5. When you are finished entering next-hop addresses, press to return to the prompt
for the Add new Generic Services menu.
6. Select any VLANs for the relay to forward to. At the prompt, enter
434=a
A screen similar to the following displays:
Available/Selected VLANS
Item Group ID:VLAN ID MASK IP ADDR
1) 1:1 255.255. 0. 0 172. 23. 9.105 *
* = selected for forwarding
Enter item number of VLAN to be selected [‘h’f or help/ to exit] :
7. Enter the item number of the group/ VLAN that you want to select. Repeat this step for all
the groups/ VLANs you want to select. An asterisk displays next to all selected VLANs .
8. Press to return to the Add new Generic Services menu. Add any other generic
services in this way.
9. Enter d to keep the current changes and return to the Generic Services menu. Enter d to
return to the UDP Relay Configuration screen.
10. Enter s to save the changes and reinitialize the relay.